Subdrive Constant Pressure Pump Controller
Installation Instructions

 

Install your Subdrive constant pressure pump control inside where it will not be subject to weather elements.

Wire direct to you house service entrance panel, not to an extension of power at a subpanel.

Do not run power to the Subdrive control or the pump in parallel to house power.

Keep incoming power separated from other circuits by at least 8 inches.

When you must cross over another power run, do it at a 90 degree angle to avoid parallel power problems.

Be sure your incoming service entrance of power is grounded properly to a ground stake prior to coming into the service panel, and then use that ground all the way to your pump.

Use the service entrance ground for your constant pressure pump system, and avoid using multiple ground sources.

Avoid multiple ground paths for best performance with the Subdrive constant pressure pump system.

Connect your motor wires from the submersible motor to the Subdrive constant pressure pump control.

Connect incoming power to the power connectors in the Subdrive constant pressure pump control.

Connecting the pressure switch into the Subdrive constant pressure pump control is easy.

The size of your constant pressure pump system determines the size of the pressure tank.

Adjust the pressure switch to give you constant pressure at a desired pressure.

Back to Constant Pressure Systems

Download our catalog in pdf format