6P Series submersible pumps in 50 gpm, 80 gpm, 120 gpm from 5 hp up through 30 hp have 3" discharge which is Cast Iron with closed sintered lead free sleeve bearing. Motor brackets are for 4" and 6" NEMA standard motors. Suction screen is 430 SST. Motor coupling is a one piece SST.

Staging is 304 heavy wall SST shell, fiberglass reinforced Noryl(R) diffusers and axial mixed flow impellers, acetal diffuser plates. Stage Bearings are SST sleeve and marine rubber radial bearing. Thrust Collar is SST thrust bearing in each stage. Pump shaft is 416 SST 3/4" hex drive shaft. Cable Guard is 302 SST. Note that these pumps do not have a built in check valve. You need to supply a check valve for above the pump.

6T & 8T Series submersible pumps in 150 gpm, 200 gpm, 250 gpm, 325 gmp, and 400 gpm, from 5 hp up through 100 hp have Cast Iron Discharge in 3" NPT on 6T series, 4" NPT on 325 gpm 8T series, and 5" NPT with enclosed bearing on 400 gpm 8T series. Motor bracket is Cast Iron with bronze sleeve bearing. For 4, 6 and 8 inch. NEMA standard motors (Availability varies with model).

Suction screen is 416 SST as is the Motor Coupling. Sand Collar is bronze, which helps to protect the motor bracket bearing from sand. Staging is Cast Iron procelain lined threaded bowls with 304 SST impellers. Bronze impellers in 200 gpm pumps. Staging bearing is rubber and bronze. Collet is 416 SST split tapered design locks impeller to shaft. Thrust collar is bronze which helps protect against upthrust. Pump shaft is 416 SST and the Cable Guard is SST.